And another short session where I forgot to set the camera right.
4/27/15
4/24/15
Countersinking in the dark..
No but not only did my cold make it into a less than a one hour session, it also made me miss that the camera was set for shooting in a much lighter environment:
4/21/15
4/19/15
Started on the back spars
Nothing done tonight, this is from friday's session, I was to tired to blog then.
 |
| Finding the parts |
 |
| Preparing the parts |
 |
| Aileron hinges sub assemblies put together and match drilled. All or most parts layed out |
4/16/15
4/13/15
4/12/15
Ribs riveted on spars
I have some to drill out but all in all it was a good session with lots of rivets driven.
4/11/15
Ribs on Spars
Most of the ribs are now attached to the spars. During the day I spent an hour cleaning the garage and putting up some more shelves.
Then I clecoed the ribs to the spars, attached the bolts and nuts and torqued them as described in chapter 5. I used 4.7Nm.
Then I clecoed the ribs to the spars, attached the bolts and nuts and torqued them as described in chapter 5. I used 4.7Nm.
4/10/15
Ribs, the never ending story ;)
All flap hinges are in place and the attachments for the inner ribs as well.
 |
| Started with drilling out two bad ones from yesterday |
 |
| Lägg till bildtext |
 |
| Clamps are great to keep parts attached |
4/9/15
Riveting
Two sessions today. Unfortunately I did not have the camera pointed in the right direction most of the time.
 |
| touched up on the primer |
 |
| one flap hinge riveted |
4/8/15
4/7/15
4/6/15
Started on the right side ribs
Left side ribs done, started going over the right side ones with red scotch brite.
4/5/15
4/3/15
Subscribe to:
Posts (Atom)